Part from a Delta 34-444 Table Saw. The saw was in good working order when it was removed. This will mount to most cast topped 27 deep table saws. Jet used the same fence and rails on their saws of this generation.
Read more…delta
Has some scratches and spots.
Read more…Includes rails & mounting hardware only, exactly as shown. Rails measure1.38 (aka 35MM) in diameter.
Read more…DELTA RT FENCE FOR 33-050 SAWBUCK TRIM SAW. NEW OLD STOCK- ORIGINAL DELTA PART.
Read more…Delta Rockwell Contractor 10″ Table Miter Mitre Gauge 18″ x 3/4″ x 3/8″. In good working condition, but has scratches, signs of use, paint over-spray and surface marks. Please view all the pictures to see what is included and condition of items.
Read more…The rail on this fence is extra long at 43 and a rare find! On most models, the silver rail is only 33-1/2 long. This fits a Unisaw Fence Rail that is. 3.4 inches wide. 1-3/4 tall on the front side. About 2 tall on the end that mounts to the saw. There is some …
Read more…As shown in photos, the rail measures about. 3-3/8 inches wide. 1-3/4 tall on the front side. About 2 tall on the end that mounts to the saw. Minor cosmetic wear as shown in pictures. No mounting bolts included. This rail is to be used with Unifence guide which is part number 422-27-012-xxxx (NOT included), …
Read more…Motor runs but has some surface rusting on casing. Includes switch and wiring.
Read more…Includes rip fence only, exactly as shown… Fits rail that is 1.38 (aka 35MM) in diameter. The length of this rip fence is meant for a 10″ table saw with a cast iron top that measures 27″ deep (when measured from to back), not including the rails. NOTE – it will NOT fit a top …
Read more…323 w6 W 11.2# 45 F. Here is a used working DELTA Rockwell TABLE SAW FENCE. No micro adjustment knob, damaged rear clamp. For repair or parts. I have seen these on uni-saws and contractor models. Has paint on it a shown. It fits models with 27″ deep tables and uses bars that are 1 …
Read more…