Pre owned shows cosmetic wear and missing the plastic piece. Please see images for condition and measurements.
Read more…delta
There’s the faintest sign of blade rash as shown in photo #2… If this bothers you an easy remedy is to add a sacrificial board of wood/plastic/plexiglass, etc. Fits a Unisaw Fence that is. 3.4 inches wide. 1-3/4 tall on the front/narrow end. About 2 tall on the back/wider end. For even more table saw …
Read more…Just a small bit of blade rash (and a scratch) as shown in photo #2… If this bothers you an easy remedy is to add a sacrificial board of wood/plastic/plexiglass, etc. Fits a Unisaw Fence that is. 3.4 inches wide. 1-3/4 tall on the front/narrow end. About 2 tall on the back/wider end. For even …
Read more…Came off of a 34-670 22.25 wide cast top. See pictures for condition. Some binding at end of rail with measuring tape. You may need to make some adjustments for smooth sliding.
Read more…Shows normal signs of wear. Dirty, dusty, rusty, paint splatter, chips, etc. 3.5 tall fence. 33.5 long aluminum extrusion. Fits unisaw guide rail.
Read more…No Other Part or Accessory.
Read more…Shows normal signs of wear. 3.5 tall fence. 33.5 long aluminum extrusion. Fits unisaw guide rail.
Read more…Delta Table Saw 34-670 or 36-380 36-600 Rip Fence for Round Guide Rails VERY NICE. This is only for Delta Table saws having a 24 1/4 (front to rear) cast iron top. This also only works for Delta saws with guide rails that are round 27 mm diameter. Very Good to Excellent Condition. The paint …
Read more…Works fine, just doesn’t look the best.
Read more…A completely reconditioned vintage Delta fence for a 20 band saw. Full size Delta Unisaw table saw rails bolt up to the 20 band saw perfectly. With Unisaw rails on your band saw, you can use the Unisaw Micro-set fence, but as they come directly from the Unisaw they are too long for the width …
Read more…