This is a rip fence from a vintage Delta/Rockwell unisaw. It fits saws with a 27inch deep table and 1 3/8 inch mounting tubes. The fence is missing (1) a bolt that screws into the top of the fence and (2) the knob that goes on to the end of the fine adjustment gear. The …
Read more…delta
NOTE – the last four of the part number (aka “2004”) I believe is the year manufacturered… I have seen 2003, 2004, and 2006 printed as those last 4 digits. They all fit the same guide rail, just slightly different color/finish. Includes ONLY the parts shown… Has been sanded and given a fresh coat of …
Read more…Pre owned shows cosmetic wear and missing the plastic piece. Please see images for condition and measurements.
Read more…There’s the faintest sign of blade rash as shown in photo #2… If this bothers you an easy remedy is to add a sacrificial board of wood/plastic/plexiglass, etc. Fits a Unisaw Fence that is. 3.4 inches wide. 1-3/4 tall on the front/narrow end. About 2 tall on the back/wider end. For even more table saw …
Read more…Just a small bit of blade rash (and a scratch) as shown in photo #2… If this bothers you an easy remedy is to add a sacrificial board of wood/plastic/plexiglass, etc. Fits a Unisaw Fence that is. 3.4 inches wide. 1-3/4 tall on the front/narrow end. About 2 tall on the back/wider end. For even …
Read more…Came off of a 34-670 22.25 wide cast top. See pictures for condition. Some binding at end of rail with measuring tape. You may need to make some adjustments for smooth sliding.
Read more…33.5 RAIL – Delta Unisaw Unifence Saw Guide Table Saw Rip Fence Assembly. Minor wear and discolorations.
Read more…Shows normal signs of wear. Dirty, dusty, rusty, paint splatter, chips, etc. 3.5 tall fence. 33.5 long aluminum extrusion. Fits unisaw guide rail.
Read more…No Other Part or Accessory.
Read more…Shows normal signs of wear. 3.5 tall fence. 33.5 long aluminum extrusion. Fits unisaw guide rail.
Read more…