100% Satisfaction Satisfaction Guaranteed. Table Saw Precision Miter Gauge System Multi-Track Fence with 27 Angle Stops. Power Tool Accessory Type. 3.0 inches x 4.12 inches x 24.5 inches. Weight: 5.8 lb. Cross & miter cuts with built-in stops, no calibration needed. 27 indexing angle stops for fast, accurate adjustments. Exceptional cut-length control with easy flip-stop …
Read more…admin
For table Saw Fence Stop Gauge Aluminum Alloy with 10-360mm and 360-710mm Scale. Accurate Scale: Features clear dual-range graduations (10-360mm and 360-710mm) etched on an aluminum alloy ruler face for accurate repeatable cuts. Adjustable Slide Block: Allows FOR rapid positioning and firm locking of the fence for consistent for dimensional control during sizing operations. Aluminum …
Read more…Some rust/wear as shown in the photos… Could use some sanding and a fresh coat of paint. Will fit any Sears Craftsman Rip Fence System for Saws with 27 deep cast iron tops (when measured from front to back). Includes rip fence only. Must have the 1-1/4 thick guide rails on front and back. If …
Read more…Accurate Scale: Features clear dual-range graduations (10-360mm and 360-710mm) etched on an aluminum alloy ruler face for accurate repeatable cuts. Adjustable Slide Block: Allows FOR rapid positioning and firm locking of the fence for consistent for dimensional control during sizing operations. Aluminum Alloy Build: Ensures a sturdy, lightweight guide FOR surface that stays flat against …
Read more…I could not figure out how to get the locking mechanism to work. I think previous owner removed the guts that go to the rear clamp and also replaced a rubber wheel on the front that is very rough. They were using a c-clamp to hold the rear of the fence in place. Unit has …
Read more…Craftsman 24″ x 14″ Router Table and Fence #29LCN-981. This item was not used. The only wear are some scratches from storage on the top. Please see all photos to better know the size and condition.
Read more…Rip Fence Rails (rails only) Delta Tilt Top Table Saw Models 1160 34-305 34-307. NOTE: This is only for the rails, the rip fence is not included. Both of the The rails are 36 long. The mounting holes for the rails are at 16 apart. The rails are 1 3/8 diameter. Includes all 4 special …
Read more…Multi use woodworking machine: cutting, sanding, drilling, turning and shaping machine. This Shopsmith Mark V in very good condition. It comes with table saw, fence, wood lathe tool support, tailstock & cutting tools, 12 inch sanding disc, push blocks & feather boards, drill chuck and 10 inch carbide tipped blade. This Mark V has the …
Read more…Magswitch Pro Table Featherboard Magnetic 81101302 Right-Side Vertical. The Magswitch Pro Table Featherboard is a professional woodworking accessory designed to improve cutting accuracy on table saws and band saws. This vertical featherboard applies downward pressure to hold materials firmly in place during cuts, preventing thin stock from lifting or bending. Two powerful 30mm magnets provide …
Read more…Unifence aluminum t-fence 43 inches long.
Read more…