Fits a Unisaw Fence that is. 3.4 inches wide. 1-3/4 tall on the front/narrow end. About 2 tall on the back/wider end. For even more table saw parts!
Read more…July 2023
You are browsing the site archives for July 2023.
Craftsman XR-2424 Table Saw Fence Aluminum Pull Down Rip Fence. This fence works good. It has a few scuffs and some rust underneath. Very solid rip fence.
Read more…Delta 34-670 36-600 Table Saw square design Fence 25. This fits the square design rails 25 inches front to back. A VERY NICE PIECE Clamps well. Clamping mechanism works very well.
Read more…Brand new and high quality. A miter gauge consists of a long thin guide, which rides in the miter slot of your table saw (some band saws also have miter slots), and guides the miter gauge parallel to the blade. Attached to this guide is a half-moon shaped piece that pivots on its connection point …
Read more…Fasteners and Spacers as shown. See photos for details. Removed from a working Craftsman model 113.24280. Should fit just about any Sears Craftsman Rip Fence System for Saws with 20 Cast Iron Deep Table Tops (when measured from front to back). Note – this style fence does not use a back rail… The fence simply …
Read more…RIP FENCE ONLY, exactly as shown. NOTE – the instructions are included which will guide you in mounting the back rear hold down piece (included) in the correct location for your saw (if you choose to use it, it’s not necessary). Fits a Front rail that is in 2 diameter.. Visit my online shop. For …
Read more…NOTE – the plastic indicator “glass” had to be repaired as shown in photo #3. See photos for details. Fits a Unisaw Fence that is. 3.4 inches wide. 1-3/4 tall on the front/narrow end. About 2 tall on the back/wider end. For even more table saw parts!
Read more…Solid rack & pinion fence system off of a Rockwell 34-440 table saw.
Read more…