Guide rails and mounting hardware are NOT included. Removed from a working C10FL model Hitachi saw. It may work for other models but I can’t guarantee that. However if you decide to try this for a different model worst case scenario you can re-list or re-sell it. For even more table saw parts.
Read more…only
NOTE – 2412 refers to 24″ rip width on the right side, 12″ rip width on the left side. However that’s referring to the GUIDE RAILS… NOT the rip fence itself. As such, this rip fence will also work just fine in place of a XR2424 fence. NOTE – THIS RIP FENCE IS NOT A …
Read more…Guide rails and mounting hardware are NOT included. Removed from a working C10FL model Hitachi saw. It may work for other models but I can’t guarantee that. However if you decide to try this for a different model worst case scenario you can re-list or re-sell it. For even more table saw parts.
Read more…The closeup photos of the rail are only there so you can see the matching size it fits. Fits 2.5″ x 1.5″ rail ONLY… It will NOT fit a 3″ x 2″. If you need the rails, checkout the corresponding rails at. For even more table saw parts!
Read more…Removed from a working 152.221140 table saw. Rip fence is NOT included, but if you need a complete system v. For even more table saw parts!
Read more…RIP FENCE ONLY, exactly as shown. NOTE – the instructions are included which will guide you in mounting the back rear hold down piece (included) in the correct location for your saw (if you choose to use it, it’s not necessary). Fits a Front rail that is in 2 diameter.. Visit my online shop. For …
Read more…The closeup photos of the rail are only there so you can see the matching size it fits. Fits 2.5″ x 1.5″ rail ONLY… It will NOT fit a 3″ x 2″. If you need the guide rails as well… For the matching guide rails. For even more table saw parts!
Read more…Came off a working 152.221140 table saw. Includes the RIP FENCE ONLY. If you need the guide rails, checkout my online shop. To see if they are available. Visit my online shop. For even more table saw parts!
Read more…Removed from a working Craftsman model 113.226880. Will also fit a 113.298090 as well as any Sears Craftsman Rip Fence System for Saws with 20 Cast Iron Deep Table Tops (when measured from front to back). As a starting point, I believe it fits the following models, but see notes above and measure before purchasing. …
Read more…NOTE – FOR PARTS ONLY… This is the front portion and shaft of the rip fence only… It’s missing the internal rod and it’s missing the end piece that clamps onto the back rail. RAILS ARE NOT INCLUDED/. Fits a front rail that is 1.38 (35mm) in diameter. The length of this rip fence is …
Read more…