I have a nice. Table saw Square Fence Rails. Off of model 34.670.
Read more…deltarockwell
For consideration I have this Vintage Delta/Rockwell Table Saw Fence as shown. Came off a parted out 34- 500. It’s made for a table with a depth of 22. It will also work for the 34-600 (8) saw, as the two saws utilize the same fence guide rails.
Read more…I have a really nice Delta/Rockwell Table Saw Jet Lock Fence Front Clamp Body. Off of model 34.444. Takes 1 3/8 diameter rails.
Read more…I have a nice Delta/Rockwell Table Saw Jet Lock Fence off of model 34.410, uses 1 3/8 fence rails. Fits 27 deep tables. Has been completely disassembled, lightly sanded, lubed and repainted.
Read more…Shows normal signs of wear. Dirty, dusty, rusty, etc. Micro adjust for jet lock. Appears to have been repaired and repainted at some point.
Read more…Shows normal signs of wear. Dirty, dusty, rusty, etc. Micro adjust for jet lock.
Read more…For consideration I have this Vintage Delta/Rockwell Table Saw Fence as shown. No major Saw Rash as shown. Came off a parted out 34- 600. The Locking Plate as shown in the last photo is an GNC Aluminum after Market Upgrade.
Read more…It looks new, but it’s not. I personally cleaned it up and spray painted it the gray again. It does have a flaw as you can see in the pictures. It has a crack where it hugs the fence rail but it’s been welded. It’s not a very nice weld, other than that it works …
Read more…Solid rack & pinion fence system off of a Rockwell 34-440 table saw.
Read more…