Includes rip fence system, exactly as shown… The length of this rip fence is meant for a 10″ table saw with a cast iron top that measures 27″ deep (when measured from to back), not including the rails. NOTE – it will NOT fit a top that measures 22-1/4 from front to back. Visit my …
Read more…deep
Shows signs of expected wear such as scratches scuffs and rust. WE DO NOT ALTER CUSTOM FORMS. WE DO NOT CHANGE ADDRESSES AFTER ORDER. IF YOU DO NOT SEE IT ASSUME ITS NOT INCLUDED. MOST OUR ITEM ARE USED UNLESS OTHERWISE STATED. ACCEPTED BACK UNDER ANY CIRCUMSTANCE. YOU MAY HAVE TO ASK YOUR DEALER FOR …
Read more…Craftsman 113 Series 10″ Table Saw Rip Fence & Guide Rails, for 27″ deep tables. Disassembled off a working 10 Craftsman table saw 113.29809.
Read more…Includes rip fence only, exactly as shown… Fits rail that is 1.38 (aka 35MM) in diameter. The length of this rip fence is meant for a 10″ table saw with a cast iron top that measures 27″ deep (when measured from to back), not including the rails. NOTE – it will NOT fit a top …
Read more…Came off a working table saw. Good condition, exactly as shown! Some slight blade rash as shown in the photo, however note the factor drilled holes on the side which are there so you can easily mount a board or a piece of nylon/plexiglass/etc so you have a nice smooth edge to glide along. NOTE …
Read more…Sears Craftsman 10″ table saw fence that came off a model 113.29900 whose table bed is 27″ deep and has a geared tooth rail that this fence goes on. Gear teeth on handle are in very good condition. Fence is in very good condition and ready to use. Some finish loss on gray hub. Last …
Read more…For consideration I have this Vintage Delta/Rockwell Table Saw Fence as shown. No major Saw Rash as shown. Came off a parted out 34- 600. The Locking Plate as shown in the last photo is an GNC Aluminum after Market Upgrade.
Read more…Fits rail that is 1.38 (aka 35MM) in diameter. The length of this rip fence is meant for a 10″ table saw with a cast iron top that measures 27″ deep (when measured from to back), not including the rails. NOTE – it will NOT fit a top that. Measures 22-1/4 from front to back. …
Read more…Craftsman Align a rip fence from. Craftsman 315 series table saw. This fence is in good working order but shows signs of use.
Read more…Includes rip fence only, exactly as shown… Has been cleaned and given a fresh coat of spraypaint. Fits rail that is 1.38 (aka 35MM) in diameter. The length of this rip fence is meant for a 10″ table saw with a cast iron top that measures 27″ deep (when measured from to back), not including …
Read more…